ASA - Linear Arm 90 Degree Tools Support Stand TSS-200QA Brand : ASA Model : TSS-200QA Preface Generally, when using electric and pneumatic screwdrivers to lock screws, there will be a reaction force applied to the operator's arm, when the torque is less than 20kgf-cm, the bare hand can also bear this reaction force, when the torque exceeds 20kgf-cm, it is necessary to use the boom to support the electric and pneumatic screwdriver to absorb the reaction force that occurs during locking to avoid arm injury. Features The standard multi-angle oil and pneumatic cylinder boom is suitable for locking angled screws regardless of horizontal and verticality. Parallel vertical oil and pneumatic cylinder boom frames, suitable for screws with high horizontal and vertical accuracy. Precautions Before starting to assemble and operate the ASA Torque Arm Tool Support System, please be sure to read the following operating manual first. Regardless of the circumstances, if electrical wires or air lines are close to running workpieces or machinery, the installers and operators of the equipment should take appropriate precautions to prevent the wires or hoses from being entangled or damaged by the running workpiece. Proper attention will avoid dangerous incidents or personal injuries. Installation and operation instructions 1.Remove the mount from the outer box. 2.Lock it on a working platform with bolts, making sure to keep the mount 1 horizontal, so that the strut 1 (02a) can be at 90 degrees to the working platform throughout the entire process. (Refer to Figure #1) 3.Install the fixing pipe 3, arm 9, and fixing plate 7 into the strut 1 (02a) respectively and fix them with screws. (See Figure #2.) 4.Insert strut 1 (02a) into the mounting seat and lock with the fixing screw. (Refer to Figure #1) 5.The sliding block 11, the sliding block 14, the sliding block 17, the strut 2 (02b), the bearing sleeve 21, the connecting arm 19, the clamping arm 24, etc. are assembled separately, and then fastened with screws together with the arm. (See Figure #3.) 6. After assembly, adjust appropriately according to the actual height of the worktable, and check that each screw is tightened, and pay attention to safety throughout the assembly process. 7.After assembly, adjust appropriately according to the actual height of the worktable, and check that each screw is tightened, and pay attention to safety throughout the assembly process.
read more