Repair
We do provide “Repairing service + Calibration adjustment”, including of parts replacement and accuracy checking.
You are welcome to contact us through Whatsapps or Wechat or Phone call for further information.
Contact Information :
Whatapps : +6016-6048808
Wechat : BryanSoon1009
Mobile : +6016-6048808
Our Repairing & Service Job Scope:
* Metrology Stamping for Weighing Scales / Metrology Stamping untuk Alat Timbang.
- MITUTOYO Measuring Instruments,
- Accuracy adjustment, replacing new parts, travelling of movement guide/screw shaft, display faulty, cleaning & servicing.
- 293 Series Digimatic Micrometer
- 570 Series Digimatic Height Gage
- 500 Series Digimatic Caliper
- 568 Series Borematic
- 368 Series Holtest
- 468 Series Digimatic Holtest
- 547 Series Thickness Gage
- 543 Series Digimatic Indicator
- Profile Projector / Video Measuring Scope
- Inaccurate reading.
- Replacing of linear scale, cross roller guide & Display Reading Unit.
- Measuring stage levelling issue.
- Replacing of new objective lens.
- Calibration adjustment.
- Weighing Instruments :
- Weighing Scale, Floor Scale, Conveyor Scale & Analytical Balance.
- Replacing new load cell, display panel & keypad.
- Replacing weighing indicator, cable & junction card.
- Accuracy check and calibration adjustment.
- Metrology stamping service.
- Rockwell Hardness Tester
- Reading inaccurate.
- Accuracy compensate adjustment.
- Replacing of Indicator Bridge & bearing.
- Pre-load setting stuck, replacing Dial Gauge & lever set amplifier.
- Humidity Chamber:
- Inaccurate of humidity reading, dry wet bulb temperature humidity sensor setting issue.
- Failure on cooling function.
- Power trip while operation reach up to certain point of low temperature.
- Replacing new cooling compressor.
- Humidity function failure, no mist out from nozzle while operation.
- Compressor overload / overpressure.
- Oven / Water Bath
- Inaccurate of temperature reading at different position point.
- Replacing a blower for ventilation & circulation features.
- Replacing heater.
- Can’t power on issue.
- Retrofit Memmert / Binder used oven by installing new Autonic Temperature & Timer Controller .
- Electrical & Electronic Equipment’s with Motor
- Can’t power on issue.
- Replacing of internal IC chips.
- Replacing of display screen.
- Replacing rechargeable battery.
- Replacing sensor.
- Taber Type Abrasion Tester
- Rotating disc lack of balance, replacing of shaft & screw.
- MTS Universal Tensile Tester
- Connection error between computer and machine.
- Replacing Interface Controller.
- Replacing new load cell.
- Upgrade new software.
- Teclock Durometer
- Reading out of accuracy.
- Mechanism calibration adjustments.
- Ozone Aging Test Chamber
- Ozone concentration (pphm) of the chamber not match with what had set.
- Tuning back by adding an amp controller over the circuit.
- Ozone generator broken, replace a new ozone generator.
- Calibration adjustment.
- Stereo Microscope
- Cleaning lens to remove any lingering dirt or particles.
- Repair Industrial Inverter
- Brand as mentioned:
- ABB, Allen Bradley, Fuji Electric, Mitsubishi, Omron, Siemens, GE Fanuc, Delta, Rhymebus, Dirise, Toshiba, Lenze, Danfoss, Hitachi, Yaskawa, Teco…